Hey Enrique, I've been printing with PLA quite a bit, and am refining my Skeinforge settings. Is there a place where we could dump copies of our Skeinforge preferences, with some simple annotations? (Edit - ah, I see there's a separate thread for that!)
So far PLA has been working quite well, but it does tend to ooze a lot more than ABS; activating Oozebane and Comb help, but also cause small sections of prints to overheat and deform. A fan helps, but I'm still working on it.
And yes, I'm quite willing to test out new settings!
Wade
So far PLA has been working quite well, but it does tend to ooze a lot more than ABS; activating Oozebane and Comb help, but also cause small sections of prints to overheat and deform. A fan helps, but I'm still working on it.
And yes, I'm quite willing to test out new settings!
Wade