@unfold: I meant on double sided tape. I've seen duct tape used as well (to my suprise) but I only said that to confuse you all ;)
@nophead: I'll also try a more closely pitched top layer. The first layer of the object will be better. Right now I have trouble removing the top layer of the raft from the object. It's probably because it's at the same temperature as object is extruded at (250+). My nozzle oozes so much and has slow starts and stops that I make the first layers of the object directly, not giving it time to change its temperature after the first supported layer.
B.t.w. I printed 5 very pretty bed corners last evening and today! Very little stringing because of comb + tower features:
[picasaweb.google.com]
Since the settings are pretty good now, I don't want to mess with them too much for a while (don't have the time to do too much experimentation, either).
@nophead: I'll also try a more closely pitched top layer. The first layer of the object will be better. Right now I have trouble removing the top layer of the raft from the object. It's probably because it's at the same temperature as object is extruded at (250+). My nozzle oozes so much and has slow starts and stops that I make the first layers of the object directly, not giving it time to change its temperature after the first supported layer.
B.t.w. I printed 5 very pretty bed corners last evening and today! Very little stringing because of comb + tower features:
[picasaweb.google.com]
Since the settings are pretty good now, I don't want to mess with them too much for a while (don't have the time to do too much experimentation, either).